Zanussi ZWT 71401 WA Manual De Instrucciones página 28

- thickness 16-22 mm
The height X depends on the height of the adja-
cent furniture's base (Fig. 3).
Fig. 3
16-22 mm
Ø 35 mm
14 mm
b) Hinges
To mount the hinges it is necessary to drill two
holes (dia. 35 mm, depth 12.5-14 mm depend-
ing on the depth of door furniture) on the inner
side of the door. The distance between the
holes hobs fixing centres must be 416 mm.
The distance from upper edge of the door to the
centre of the hole depends on the adjacent fur-
niture's dimensions.
The hinges will be fixed to the door by means of
screws for wood 1 and 2 (Fig. 4) supplied with
the appliance.
Fig. 4
c) Mounting the door
Fix the hinges to the appliance by means of the
M5x15 screws. The hinges can be adjusted to
compensate for possible uneven thickness of
the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tighten
the screw A again (Fig. 5).
28
X
416
mm
22±1,5 mm
595-598 mm
2
1
Warning! Do not remove the screw B
(Fig. 5).
Fig. 5
B
d) Counter-magnet
The appliance is prearranged for a magnetic
closure of the door.
To enable a correct operation of this device, it is
necessary to screw the counter-magnet A (steel
disk + rubber ring) into the inner side of the
door. Its position must correspond to the mag-
net B on the appliance (Fig. 6).
Warning! Do not remove the screw C.
Fig. 6
If the door has to be opened from left to right,
invert the position of the plates E, the magnet D
and the plate C. Mount the counter-magnet D
and the hinges A as previously described (Fig.
7).
Warning! Do not remove the screw B.
A
A
B
C
www.zanussi.com