Krups SAVOY ET451 Manual De Instrucciones página 8

KR_CAFETIERE_SAVOY_M5_NC00132236_Mise en page 1 14/04/2016 08:59 Page10
■ Make sure that the filter holder (j) is inserted. Fig. 9. Insert the permanent filter (k) Fig. 10a or a #4 paper
filter Fig. 10b into the filter holder (j). If using a paper filter, make sure it is fully opened and properly
positioned in the filter holder.
■ We recommend removing the filter holder with the filter before adding the ground coffee. If you accidentally
pour ground coffee into the water tank, do not start the cycle. Clean the tank, otherwise the coffee
mayblock the water circuit.
■ Add 1 KRUPS spoon (t) of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 12.
■ Close the lid (b).
■ Press the BREW/control knob (k). The control knob light will come on to show that the coffee maker has
started the BREW cycle. The machine will beep once. Fig. 13.
■ At the end, your machine will beep 3 times and the BREW/control knob (k) will turn off.
■ Remove the thermal carafe from the coffee maker so that the coffee is kept hot.
■ In order to pour coffee from the thermal carafe, press the lever on the lid. Fig. 14.
■ At any time during the BREW cycle, you may turn off the coffee maker by pressing the BREW/control knob
(k). The light on the BREW/control knob will also go out. It beeps 3 times prior to turning off.
Even if the BREW cycle has ended, there is still hot liquid in the filter. Wait a few minutes for the rest of
the liquid to flow into the carafe before removing the filter.
Note :
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
water tank, since the ground coffee and the filter absorb about 10% of it.
- The water tank is equipped with an overflow outlet at the rear of the appliance. If you add too much water,
it will come out of this opening.
- Clean the permanent filter in between each use, or use a paper filter.
CAUTION:
- To avoid overflowing, the carafe should be properly placed on the warming plate of the coffee
maker, otherwise the hot water or hot coffee may overflow.
- The coffee maker becomes very hot during the BREW cycle. Handle it carefully.
6. OTHER FEATURES
6A – AUTO START FUNCTION
Programming the auto-start settings.
■ Your appliance is equipped with two auto-start programs.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO ON button. An AUTO 1 icon displays on screen. Fig. 16.
■ Turn the BREW/control knob (k) to set the time. Confirm by pressing the BREW/control knob (k). The time is
displayed. Fig. 17 and 18.
■ Without validation with the BREW/control knob (k), the time is recorded automatically after about 5
seconds.
■ To set the second program, push the AUTO ON button twice, so that the AUTO 2 icon appears on screen.
Fig. 19.
■ Turn the BREW/control knob (k) to set the time. Validate by pressing the BREW/control knob (k). The time
is displayed. Fig. 20 and 21.
■ If you do not confirm using the BREW/control knob (k), the time is recorded automatically after about 5
seconds.
Activate a delayed start-up when the time is already pre-set.
■ Select AUTO 1 or AUTO 2 by pressing the AUTO ON button. Press the BREW/control knob (k) to launch
auto-start program.
6B – TURBO FUNCTION
This function enables you to brew your coffee faster by reducing the cycle time.
10