ADDITIONAL WARNINGS
1. Never attempt to remove any part of the
compressor whilst the tank is under pressure.
2. Never attempt to remove any electrical com-
ponent whilst the compressor is connected to
the power supply. Switch off the power and
remove the electrical plug.
3. Do not adjust the safety valve.
4. Do not use an electrical extension cable.
5. If the release valve under the pressure switch
cover fails to operate when the on/off button
is pressed down, switch the power supply off
and determine the nature of the fault.
6. Ensure that the lubricating oil is clean and
that the oil level is maintained at the mid point
of the red circle in the oil level glass.
7. Take care when discharging air from the
tank, i.e. from the safety valve, the drain cock
or the air outlet. Compressed air can be ex-
tremely dangerous. Take care the discharge air
does not cause dust, stones or any other for-
eign particles to be blown through the air and
that the air is discharged in a safe manner.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. TANK.
2. INDUCTION MOTOR
3. BELT DRIVE
4. ON/OFF SWITCH.
5. HUMIDITY DRAIN VALVE.
6. WHEELS.
1
5
6
ASSEMBLY & ADJUSTMENTS
HANDLE
The handle must be fitted in the following
manner:
1. Loosen the screws in each of the handle fix-
ing tubes using an hex key (not included).
2. Insert the two ends of
the handle into the fixing
tubes.
3. Tighten the screws to se-
cure the handle in place,
using an hex key wrench
(Fig.1).
WHEELS
Fit the wheels as follows:
1. Position the back of the wheel onto the met-
al bracket located on the tank.
2. Then insert the wheel bolt through the
wheel and then through the hole in the brack-
et under the tank.
3. Attach and tighten the nut with washer, on
the inside of the bracket tightening with two
spanners. Repeat for the second wheel.
NOTE: Tires should be inflated not exceeding
30 psi.
OIL
with oil prior first use. To prevent possible spill-
age of oil during transport, the compressor oil
is supplied in a separate container. It must be
added to the compressor before turning the
compressor on. Failure to add the oil will cause
non-repairable damage to the compressor and
will void the warranty.
2
1. Remove the plastic oil fill-
3
ing cap (Fig.4) located on the
top of the crank case of the
4
compressor housing.
2. Use the oil supplied to fill
the crank case until the oil
level as seen in the oil level
glass is up to the mid point
of the red circle (Fig.5).
3. Replace the oil filling cap.
Make sure the cap is fully fit-
ted and firmly in position.
1
E N G L I S H •
WARNING: The air compressor must be filled
U se r's m a n ua l
Fig.1
Fig.2
Fig.3
15