Publicidad
Idiomas disponibles
Idiomas disponibles
8.
Do not place a heater in use near curtains, furniture, wood paneling or combustible material which
can deteriorate with heat.
9.
While in use, ensure that children do not approach the heater.
10. Do not move the appliance when in use; the safety device may be activated by knocks or
movement.
11. This appliance should be tested for leaks before initial use and whenever the cylinder is
re-connected.
12. It is important that all gas connections have been correctly made to prevent any leakage. Do not
use naked flame to test for leaks. Use soapy water.
13. Always use your cylinder always in an upright position.
14. Always turn off the regulator control when the heater is not in use.
15. When lighting your heater for the first time or after a period of time has passed since the last use,
light the heater outside and burn outdoors for 15 minutes.
16. This appliance requires a hose and a regulator, check with your gas supplier for the correct type
according to the cylinder being used and any regulations at the time.
17. The guard on the appliance is to prevent risk of fire or injury form burns and no part of it should be
permanently removed. It does not give full protection for young children or the infirm. We would
recommend a fireguard to be fitted.
18. For the Pusher Igniter unit, it need to be installed a AAA battery
FAULT FINDING CHART
SYMPTOMS
5. Pilot
will
not
automatically
6. Pilot
will
not
automatically but points (a) to
(e) are satisfactory and the
pilot will light with a match
7. Heater will not remain alight
when pressure is released
from ignition button
8. Smell of combustion.
FAULT
light
No
spark
across
electrode gap
light
Incorrect position of
spark in relation to
pilot gas flow.
Electro-magnetic
valve closes whilst
heater is alight.
Heating temperature
become lower than
usual
- 28 -
REMEDY
6. Ensure
that
piezo-electric
functioning correctly.
7. Check that electrical lead is not damaged.
8. Check the battery power if the heater fitted
with Push ignitEr and replace a new one
Re-position spark plug so that spark jumps
across gas flow.
(e) Ensure that thermocouple probe is located
in pilot flame.
(f) Ensure
good
thermocouple and valve
(g) Check thermocouple.
(h) Check electromagnetic valve
1. Damage of the catalytic pad.
2. Gas leakage from the gas circuit pipe.
3. Faulty regulator
4. Hose ageing
ignition
is
connection
between
Publicidad
