Descargar Imprimir esta página

Jocel JAG014153 Manual De Instrucciones página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

1. LIGHTNG INSTUCTION
a. The heater has three settings. Lighting (Pos.1) and Minimum (Pos.2); Medium (Pos.3) and
Maximum (Pos.4)
b. Place the gas filled cylinder into the back of the heater.
c. Clip on the gas regulator to the gas cylinder.
d. Turn on the gas regulator.
2. LIGHTING
Press the control button for 10 seconds at the Position 1, at the same time press the piezo igniter key to
light with thumb finger of left hand, continue this procedure until pilot ignites, approximately after 20
seconds leave control button. At this stage if the pilot is alight, it means that the heater is at the
minimum position (Pos.1). If the pilot flame goes out please repeat this procedure.
3. HEAT SETTINGS
To change from minimum to maximum gently press control button and turn it to position 3.
To change from maximum to medium gently press control button and turn it to position 2.
4. TURN OFF THE HEATER
Turn and press the control knob to LIGHTNING position. Then turn off the valve on the gas cylinder. If
the heater is not used for a period of time, disconnect the regulator from the cylinder.
WARNING
Read the instructions before using this appliance.
The apparatus is not ready for the physically weak, slow response or mental disorders (including
children) to use, unless it bears responsibility for the guidance of safety or safe use of the help.
Children should be monitored to ensure they do not play apparatus.
Use an appropriate regulator (not supplied), ask your supplier to get one.
Never attempt to light if the hose is loose or damaged in any way.
Do not press the ignition button for more than 40 seconds.
Never disconnect the regulator while cylinder valve or regulator is open.
Do not change cylinder in areas in which open fire exists.
Do not expose your cylinder to extreme heat.
Do not store any other cylinders in the room in which your heater is used.
Do not insert your finger or any other material through the front panel of the heater.
Leave at least 1 meter distance between your heater and the other heat source.
- 31 -

Publicidad

loading