Haier ESA406J Manual De Uso Y Cuidado página 7

NOTES:
■
Handle the air conditioner gently.
■
Be sure your air conditioner does not fall out of the opening
during installation or removal.
■
The place where the power cord exits the air conditioner should
be no more than 4 ft (122 cm) from a grounded outlet.
(For model ESA406J,ESA408J,ESA406J-L,ESA408J-L,
ESA406J-T,ESA408J-T electrical outlet can be grounded within
6 ft (183 cm))
■
Do not block the louvers in the front panel.
■
Do not block the louvers on the outside of the air conditioner.
1. Center the air conditioner in the window. Lower the window
sash behind the top channel to hold the cabinet in place
NOTE: Your model may differ from the one shown.
A
A. Side curtain against window channel
B. Window sash behind top channel
C. Bottom channel in behind windowsill
2. Loosen the screw on the right-hand side of the air conditioner
cabinet near the bottom.
Position Air Conditioner
3. Slide the side bracket over the screw.
4. Tighten the screw. The side bracket should be resting on the
windowsill.
Use 1⁄8" drill bit to drill a starter hole through the holes in the
5.
side bracket and windowsill.
Using two 31⁄32" screws, attach the side bracket to the
6.
windowsill.
B
7. Repeat for side bracket installation on the left-hand side of
C
the air conditioner.
Attach Side Curtains to Window
1. Pull the left-hand curtain out until it fits into the window
channel.
2. Use a 1⁄8" drill bit to drill a starter hole through the top hole in
the side curtain and into the window sash.
Insert one of the 31⁄32" screws through the top hole of the
3.
lefthand curtain and into the window sash.
4. Repeat for the right-hand curtain.
Use a 1⁄8" drill bit to drill a starter hole through the bottom hole
5.
in the side curtain and into the window frame.
Insert one of the 31⁄32" screws through the bottom hole of the
6.
left-hand curtain and into the window frame.
7. Repeat for the right-hand curtain.
7