AQUA SPHERE VSP Serie Manual De Instrucciones página 10

4.5 Application conditions
Ambient temperature
Water temperature
Maximum water salt level
Humidity
Altitude
Installation
Insulation
5. SETTING AND OPERATION
5.1 Display on control panel:
5.2 Startup:
When the power is switched on, the screen will be fully light for 5 seconds, the device code
will be displayed, and then it will enter the normal working state. When the screen is locked,
only the button is lit; Press and hold
will all light up. The screen will automatically lock up when there is no operation for more than
1 minute and the brightness of the screen is reduced by 1/3 of the normal display. Short press
to wake up the screen and observe the relevant operating parameters.
5.3 Self-priming
When switched on for the first time after installation, the pump will start self-priming auto-
matically.
The system performs the self-priming in Boost mode, it will count down from 1500s and stop
automatically when the system detects the pump is full of water, then the system will recheck
for 60s again to make sure the self-priming is completed. When completed, the pump will run
at 80%.
Indoor installation, temperature range: 2-50ºC
5ºC-35ºC
6g/l (6000 ppm)
≤90% RH, (20ºC±2ºC)
Not exceed 1000m above sea level
The pump can be installed max. 1,5m above water level
Class F, IPX5
Power consumption
1
Running capacity
2
Timer period
3
Timer 1/2/3/4
4
Backwash/unlock
Up/down: to set the value (capacity/time)
Timer setting
On/off
for more than 3 seconds to unlock, other buttons
10