Publicidad
Idiomas disponibles
Idiomas disponibles
18
PROGRAMMING MODE
PROGRAMMING MODE - Setup Mode
Setup Mode :
You can change dryer vend price, cycle time, and cycle parameters, etc.
Entering set up mode
• Coin type - Turn on/off toggle switch.
• Card type - Insert the service card.
• Stack type - Take off control panel, and turn on/off toggle switch.
• OPL/Coin Type – Push "High Temp." + "Low Temp." and then enter password "3".
• Then, dryer displays
1. How to change regular price.
Entering set up
mode.
You will see LqC1
NOTE
• rgCP(regular delicate price) is not available in dryer.
• rgrP(regular warm/cold price) is not available in dryer.
• rgHP (regular hot price) is not available in dryer.
• Price setting varies by country.
• Set your country from
• After EEPT, reset your country. (Default country is KOR)
(display)
.
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Start button.
Display previous regular price.
Press Med Temp.(+) or Low Temp.(-) button to set regular price.
(The vend price can be set from 0 to 9900 in 100 increments.)
Press the Start button.
The machine sets up the regular price, then advances to the
next process automatically.
1. Continue to set up the next price.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/off toggle switch.
• OPL/Coin Type – Press "High Temp. " twice.
mode. (Refer How to enter the
Button
)
Display
Publicidad
