HQ-Power VDPLW1803RGB Manual Del Usuario página 4

Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
Mechanical wear and LEDs are not covered by warranty.
A qualified technician shall install and service this device.
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
This device is designed for professional use on stage, in discos, theatres, etc. The device shall only be used
indoors with an alternating current of 230 VAC 50 Hz.
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4. Features
direct the light where you want it, using the included and removable barn doors
easy control with built-in, eye-catching auto programs with sectional control
smooth LED fading with built-in dimming curves
ideal for noise-sensitive environments due to the radiant cooling design.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power input + fuse holder
2 DMX input
3 safety hook
4 microphone
6. Installation
Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket. Adjust the
barn doors as desired. Connect the power cord to the mains. Disconnect after use.
Mounting the Device
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
Install the device in a location with few passers -by that is inaccessible to unauthorised persons.
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
Make sure there is no flammable material within a 0.5 m radius of the device.
Have a qualified electrician carry out the electric connection.
Connect the device to the mains with the power plug. All devices must be powered directly off a grounded
switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or dimmer channel
is used solely for 0 % to 100 % switching.
The device has a power output [9] to supply power to another device. When connecting several devices in
a daisy chain via this output, make sure that the total current does not exceed the power line's nominal
current. Use power cables with an adequate section.
The installation has to be approved by an expert before the device is taken into service.
V. 02 – 11/12/2013
VDPLW1803RGB
5 display
6 double bracket
7 control buttons
8 DMX output
4
9 power output
10 light sections
©Velleman nv