HQ-Power VDPLW1803RGB Manual Del Usuario página 6

Stand-Alone Mode with Custom Static Colour
You can create a custom colour by adjusting the intensity of the red (r), green (g), and blue (b) LEDs.
To use a custom static colour:
1. Unplug any connection from the DMX input [2] of the device.
2. Press MENU until <U--> is displayed and press ENTER.
The last set colour value appears, for example <r215> = red LEDs intensity value = 215.
3. Use UP and DOWN to set the intensity (0–255) and press ENTER.
The next colour value appears.
4. Repeat for all colours until you have the desired output colour.
5. Press MENU to quit.
Stand-Alone Mode with Built-in Program
To set the device to stand-alone mode with a built-in program:
1. Unplug any connection from the DMX input [2] of the device.
2. Press MENU until <P--> is displayed and press ENTER.
3. Use UP and DOWN to select a built-in program:
P1–P13: program 1–13
o
P14: random program 1–13.
o
4. Press ENTER to confirm.
5. To set the speed of the program, press MENU until <S--> is displayed. Note: do not press ENTER.
6. Use UP and DOWN to set the speed from slow (1) to fast (100) and press ENTER to confirm.
7. Press MENU to quit.
Sound Activation
With sound activation, the built-in program responds to sound. To use sound activation with the selected built-
in program:
1. Press MENU until <Snd> is displayed and press ENTER to confirm.
2. To change the sensitivity of the internal microphone, press MENU until <SenS> is displayed. Note: do not
press ENTER.
3. Use UP or DOWN to set the sensitivity from low (0) to high (100) and press ENTER to confirm.
4. Press MENU to quit.
Dimmer Modes
You can choose a dimmer mode to control the colour transitions in the auto matic programs. The dimmer mode
has no effect on static colours.
To set the dimmer mode, proceed as follows:
1. Press MENU until <dIM> is displayed and press ENTER.
2. Use UP and DOWN to select the desired setting:
<OFF>: dimmer off, for abrupt colour transitions.
o
Note: In master/slave mode, set the dimmer to <OFF> on the slave device if you want the slave
device to use the same dimmer mode as the master device.
<DIM1 >–<DIM3>: dimming modes 1 to 3, for smooth colour transitions.
o
3. Press ENTER to confirm.
After changing the dimmer mode, you have to reactivate the automatic program, as follows:
4. Press MENU until <P--> is displayed and press ENTER.
5. Use UP and DOWN to select the desired program and press ENTER.
6. Press MENU to quit.
7.4 Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device in a daisy chain. All
slave devices will then work synchronously with the master device. The first device in the daisy chain functions
as the master device.
To set the devices to master/slave mode:
1. Unplug any connection from the DMX input [2] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output of the master device.
3. Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave device.
4. Set the DMX start address of each slave device to 1 (see DMX Mode for details).
V. 02 – 11/12/2013
VDPLW1803RGB
6 ©Velleman nv