Joovy Caboose Too Ultralight 0087X Manual De Instrucciones página 6

EN FR ES
18 Removing the Caboose Too Rear Seat
• Unsnap the waist and shoulder straps from the crotch strap. Leave the crotch strap in place to use with the stroller rear bench seat.
• Unwrap the left and right armrests of the Caboose Too Rear Seat from around the upper horizontal frame (on each side). Unsnap both
snaps on each side. See Figure 18.1.
• Near the front sides of the Caboose Too Rear Seat are 2 Velcro® straps (one on each side). Pull these straps apart. Repeat on the other
side. See Figure 18.2.
• Locate the 2 straps on the upper rear of the Caboose Too Rear Seat (one on each side). Unsnap them from around the handle bar above
the rear handles. See Figure 18.3.
• Locate the long straps on the lower rear of the Caboose Too Rear Seat. Unsnap the straps and unwrap each strap from around the
outside of the stroller handle bar by feeding them through the loops on the back of the seat. See Figure 18.4.
• Push the rear seat crotch strap (with the buckle) through the slot in the Caboose Too Rear Seat (See Figure 18.5) and pull the Caboose
Too Rear Seat off of the rear bench.
19 Installing the Rear Bench Seat Waist Strap
• To install the rear bench waist strap, locate one end of the waist strap where it has a metal D-ring at the end.
• Wrap the strap around the front seat rear tube. Slide the strap through the small opening of the metal D-ring and pull the strap to secure it
to the tube. Repeat for the other end of the strap. See Figure 19.1.
• Push the waist latch posts into the crotch buckle until all parts snap into place.
20 Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant car seat. The stroller can be folded with the infant car seat adapter and the Caboose Too Rear Seat in place.
• Close the canopy and push it forward.
• Put the front seat and Caboose Too Rear Seat (if attached) into their most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• Unlock the safety latch on the lower left side of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller and push the handle fully forward. See Figure 20.1.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
• Engage the fold lock on the right side of the stroller over the mounting post. See Figure 20.2.
21 Using the Stroller with an Infant Car Seat (OPTIONAL)
NOTE: See insert for a list of specific compatible car seat models.
• Remove the front tray and install the infant car seat adapter on the same mounts. Ensure it is secure on BOTH sides. See Figure 21.1.
• Push the canopy to its most rearward position.
• ADJUST THE SEAT TO ITS SECOND (MIDDLE) POSITION.
• Remove the infant car seat from its base and place it onto the front seat of the stroller so it is in a REAR FACING POSITION. Position the
"head" end toward the front, resting on the infant car seat adapter. Position the "feet" end on the seatback - but NOT on the top edge of
the seatback. See Figure 21.2.
• Buckle the red restraining straps over the LOWEST part of the infant car seat (the straps are located in the pockets on the side of the
seat) Adjust the straps so they are tight around the infant car seat but AWAY from the child's neck. Pull up on the infant car seat to be sure
it is secure. See Figure 21.3.
• To remove the infant car seat from the stroller, unlock the restraining strap buckle by pressing the button and both side releases.
See Figure 21.4.
• Return the restraining straps to their pockets.
WARNING
!
The rear seat is not suitable for children under 6 months.
ALWAYS ensure that the seatback is secured into its position.
Push down on the seatback to be sure it is secure.
NEVER adjust the seatback when the child is in the seat.
WARNING
!
ALWAYS keep children away from the stroller when folding.
Possible pinching hazard - Be careful when folding the stroller.