Publicidad
Idiomas disponibles
Idiomas disponibles
4. OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE CLEANER!
4.1 STARTING UP
After connecting the pressure cleaner to your cold water supply,
proceed as follows:
· Make sure that the ON/OFF switch is in the OFF position.
· Connect the garden hose to the inlet fitting.
· Attach the hose to the gun as per assembly instruction step #1.
· Install gun hook and power cord hook, screw the gun holder as
per assemble instruction step #2.
· Screw the washer handle tight to the main body as per
assemble instruction step #3.
· Insert the adjustable spray nozzle into the gun as per assembly
step #4.
· Connect the high pressure hose to the high pressure outlet
fitting as per assembly step #5.
· Connect the garden hose to the high pressure washer inlet
fitting as per assembly step#6.
· Open the water supply valve completely.
· Before turning the unit on, press the gun trigger to bleed all the
remaining air out of the pump and hose.
· Start the pressure cleaner by turning the on/off switch to the on
position and squeeze the trigger.
· REMINDER: Motor does not run continuously, only when the
trigger is squeezed.
WARNING! RISK OF INJECTION! UNIT WILL START
SPRAYING WHEN TRIGGER IS SQUEEZED. WHEN TURNING THE
UNIT OFF AFTER USE, HIGH PRESSURE STILL EXISTS INSIDE
THE HOSE AND UNIT. POINT THE GUN IN A SAFE DIRECTION
AND DISCHARGE THE EXCESS PRESSURE. NEVER DIRECT THE
HIGH PRESSURE WATER STREAM AT PEOPLE OR ANIMALS.
4.2 AUTOMATIC ON/OFF
The pressure cleaner is equipped with an automatic on/off switch.
The pressure cleaner will only run when the power switch is in
the ON position and the trigger on the gun is squeezed. When you
release the trigger to stop spraying water through the gun, the motor
on the pressure cleaner will automatically shut off. Simply squeeze
the trigger again to resume using the cleaner. To stop using the
pressure cleaner, release the trigger and switch the unit to the OFF
position. The unit should be turned completely OFF while not in use
or while unattended.
4.3 BLEEDING THE GUN
It is very important to bleed the gun before using the pressure
cleaner. Refer to the "Assembly Instructions" to assemble the
pressure cleaner. To bleed the gun, simply connect the garden hose
to the pressure cleaner and squeeze the trigger BEFORE turning the
electrical supply on. This allows any air trapped inside the pressure
cleaner and gun to be removed before using the unit. Continue
holding trigger for approximately one minute to allow any excess
air out of the unit. Water will flow through the gun at low pressure
during this procedure. For more bleeding tips, see the section titled
"Operating Instructions
ENG - 04
Publicidad
