Publicidad
Idiomas disponibles
Idiomas disponibles
4.7 USING DETERGENTS
WARNING! THE PRESSURE CLEANER WILL DISPENSE
DETERGENT AT LOW PRESSURE. USE THE ADJUSTABLE
SPRAY NOZZLE TO RINSE CLEAN.
BIODEGRADABLE DETERGENTS ARE SPECIFICALLY
FORMULATED TO PROTECT THE ENVIRONMENT AND YOUR
PRESSURE CLEANER. THESE DETERGENTS WILL NOT CLOG
THE FILTER AND WILL PROTECT THE INTERNAL PARTS OF THE
PRESSURE CLEANER FOR A LONGER LIFE.
The built-in detergent dispenser will allow you to apply many forms
of liquid detergent onto the work surface. Detergent application
happens at low-pressure only. Insert the adjustable nozzle onto the
gun, and push it toward end of " " , so that the pressure washer is
in low-pressure mode (see Figure A below). Remove the cap on the
detergent reservoir and fill with liquid detergent only (see Figure B
below). Do not put any water into the reservoir. The pressure washer
will mix water and detergent automatically.
If you need to adjust the detergent rate , you can turn the knob to the
left end for bringing down it and turn the knob to the right end for
raising it ,that depend on your specific cleaning demand (see Figure
C below) .
When finished applying the detergent to the work surface, pull it to
end of "
" of the adjustable nozzle and spray off the detergent by
using the high-pressure spray (see Figure A below). In high-pressure
mode, the pressure washer will not dispense detergent.
FIG A - FIG B
WARNING! NEVER USE PRODUCTS WITH BLEACH
OR CHLORINE OR ANY OTHER CORROSIVE MATERIALS,
INCLUDING LIQUIDS CONTAINING SOLVENTS (I.E. GAS, OILS
ETC), TRI-SODIUM PHOSPHATE PRODUCTS, AMMONIA, OR
ACID-BASED CLEANERS. THESE CHEMICALS WILL HARM THE
UNIT AND CAUSE DAMAGE TO THE SURFACE BEING CLEANED.
ALWAYS READ THE LABEL.
FIG C
5. CLEAN-UP AND STORAGE
5.1 SHUTTING DOWN THE PRESSURE CLEANER
WHEN FINISHED USING THE PRESSURE CLEANER, FOLLOW THESE
STEPS TO SHUT DOWN THE UNIT:
· Turn the pressure cleaner to the OFF position.
· Turn off the water supply.
· Before disconnecting high-pressure hose connection, point the
gun in a safe direction and discharge the high-pressure water.
· Disconnect high-pressure hose from the pressure cleaner and gun.
· Disconnect garden hose from the pressure cleaner.
· Remove quick coupler fitting from garden hose and attach to
the nipple portion of the fitting installed on the pressure cleaner
for storage.
· Remove excess water from the pump by tipping the unit on
both sides to drain any remaining water from inlet and outlet
fittings.
· Remove Water Intake Filter and flush with water to remove dirt
or debris. Return filter once cleaned.
· Drain detergent reservoir and flush with running water.
· Wipe away any remaining water on all parts and fittings.
· Engage the gun safety lock.
· Store the pressure cleaner, parts, and accessories in an area
with a temperature above 0ºC (32ºC).
5.2 WINTERING AND LONG-TERM STORAGE
FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES, ADDING
THE FOLLOWING STEPS:
· After disconnecting the water supply, and before disconnecting
the high-pressure hose, turn the pressure cleaner on for 2-3
seconds, until any remaining water in the pump exits. TURN
UNIT OFF IMMEDIATELY.
¡CONTINUED USE OF THE PRESSURE CLEANER WITHOUT
WATER SUPPLY ATTACHED WILL CAUSE SEVERE DAMAGE
TO THE UNIT!
· Always store the pressure cleaner, parts, and accessories in an
area with a temperature above 0° C (32° F).
WARNING! FAILURE TO COMPLY WITH THESE STORAGE
INSTRUCTIONS WILL RESULT IN DAMAGE TO THE PUMP ASSEMBLY.
5.3 MAINTENANCE
· This pressure cleaner is supplied with a closed lubrication
system, so no addition of oil is needed.
· Check all hoses and accessories for damage prior to use.
· Check the inlet filter periodically for deposits. Clean this filter
regularly for maximum performance
5.4 CLEANING TIPS
WARNING! ALWAYS TEST THE SPRAY IN AN AREA FREE
AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU SPRAY AT
THE INTENDED CLEANING SURFACE
.
Publicidad
