Publicidad
Idiomas disponibles
Idiomas disponibles
up the handlebar stem with the holes
and fit the 3 Allen screws (14) and the
curved washers (13), tighten securely.
6.- ATTACHING THE SADDLE.-
Place the saddle (23) onto the saddle
post (22), as shown in Fig.6, bearing in
mind that the holes on the saddle post
go at the front section of the saddle,
position the saddle correctly and
tighten nuts (11) securely. Now insert
the saddle post into the hole on the
main body (1), fit the saddle post knob
(21) and adjust the height of the saddle
and tighten it into position by turning
the saddle post knob (21) clockwise.
7.- ADJUSTING THE SADDLE
HEIGHT.-
Loosen the saddle post knob (21) a
little, turning it anticlockwise, and pull
it back, Fig.6, adjust the height of the
saddle to suit the exercise and then
release the knob so that it slots back
into one of the holes on the saddle
post. Tighten the knob (21) securely
by turning it clockwise.
8.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (29), marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.7.
The left-hand pedal (28), marked with
the letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.7.
Once the pedals have been fitted,
insert the end of the pedal clip (A) into
the slot on the pedal (B) adjusting it to
your footwear on the ledge of the
pedal (C), Fig.7A.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (46) up or down, as
shown in Fig.8.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (48)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.9. Store your unit in a dry place,
preferably not subject to changes in
temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
14
direction.
Tighten
Publicidad
