Black and Decker CM2045 Manual De Instrucciones página 10

the front of both handles. If it is not it may
result in the cord tangling and the inability
to easily store the mower (Figure I).
• From the outside
of the upper
handle (3), slide
the lever/knob bolt
through the holes.
• Slide the washer
over the bolt and
loosely assemble
the entire
assembly with
the nut.
• Rotate the upper
handle into its
operating position.
• Close the lever, or tighten the knob. If the
lever is too tight or too loose, open the
lever and the nut to adjust the clamping.
Check the levers by closing them. They
should be tight enough so the handles
are held firmly, but loose enough so
the levers can be fully closed. Adjust by
opening the lever and turning the nut until
the handles are secured.
SECURING THE MOTOR CABLE
(FIGURE J)
CAUTION:
ATTACH CABLE SO
THAT IT DOES NOT BECOME
STRETCHED OR PINCHED IN THE
JOINTS OF THE HANDLES DURING
USE OR FOLDING. THIS CAN CAUSE
DAMAGE TO THE CORD.
The motor cable (22) has to be fixed to
the handles using the cable restraints (23)
that are already attached to the handle.
To clip the cable to the handle:
• Place the handles in operating position,
see "Attaching Lower Handle" section.
• Run the cable up the front of the lower
and upper handles.
• Pull back the cable restraint.
• Slide the motor cable under the clip
and ensure it is fully held in place by
the restraint.
J
23
I
22
10
BAGGING
• Ensure the side discharge attachment
(27) (Figure M) and the mulching insert
(26) (Figure L) are removed from the
mower before bagging.
• Lift the rear door cover (9) and place
the grass collection bag (8) onto the
mower so the bag hooks (24) rest on
the lugs (25) as shown in Figure K.
Then lower the rear door cover.
K
9
MULCHING
• Ensure the side discharge attachment (27)
and the collection bag (8) are not attached.
• Lift the rear door cover (9) and slide the
mulching insert (26) fully into the mower
as shown in Figure L.
• Ensure the rear door cover fully closes
before turning mower on.
L
SIDE DISCHARGE
• Ensure the collection bag (8) is removed.
• Lift the rear flap (9) and slide the
mulching insert (26) fully into the mower
as shown in Figure L.
• Lift the side flap (28) and hook side
discharge attachment (27) onto the
mower as shown in Figure M.
• Release the side flap and ensure
the attachment holds in place before
turning mower on as shown in the insert
of Figure M.
8
24
25
26