Publicidad
Idiomas disponibles
Idiomas disponibles
•
Number of teeth on bar tip sprocket (T).
•
Chain pitch, in. The distance between the drive links
of the saw chain must align with the distance of the
teeth on the bar tip sprocket and drive sprocket.
D
•
Number of drive links. The number of drive links is
decided by the type of guide bar.
•
Bar groove width, in/mm. The groove width in guide
bar must be the same as the chain drive links width.
•
Chain oil hole and hole for chain tensioner. The
guide bar must align with product.
28
D
PITCH =
2
•
Drive link width, mm/in.
General information about how to sharpen the
cutters
Do not use a blunt saw chain. If the saw chain is blunt,
you must apply more pressure to push the guide bar
through the wood. If the saw chain is very blunt, there
will be no wood chips but sawdust.
A sharp saw chain eats through the wood and the wood
chips becomes long and thick.
The cutting tooth (A) and the depth gauge (B) together
makes the cutting part of the saw chain, the cutter. The
difference in height between the two gives the cutting
depth (depth gauge setting).
When you sharpen the cutter, think about the following:
•
Filing angle.
•
Cutting angle.
•
File position.
A
B
987 - 003 - 30.01.2019
Publicidad
