Publicidad
Idiomas disponibles
Idiomas disponibles
6.
MAINTENANCE
EN
Unplug the drill and the heater from the power source before
performing any maintenance intervention.
DRILL PRESS
Keep the drill-press column clean and lubricated.
Do not clean the guide with abrasive rags or corrosive substances.
BRAKE PAD
If the column press tends to slide down, tighten the brae-pad:
1. loosen the lock nut and fix the hexagonal screw recessed inside it.
2. Re-tighten the lock nut
HOT IRON
At the end of each welding, clean the surface of the dies, still at
the operating temperature, with a suitable cleaning flux.
DRILLING MACHINE
Check the wear of the hole saws and chuck.
7. TROUBLESHOOTING
Unplug the drill and the heater from the power source before
performing any maintenance intervention.
Read the hot-iron handbook
18
Notice
The technical characteristics of the machine and the data shown in this manual
may undergo variations without notice at the discretion of the manufacturer.
It is strictly prohibited to reproduce this document or part of it in any form
whatsoever.
Full spare part list and technical documents available online at www.ritmo.cloud.
Help in the event of problems:
S.p.A.
via A. Volta, 35/37 - Z.I. Selve
35037 BRESSEO DI TEOLO (PD)
ITALY
Tel. +39.049.990.1888
Fax +39.049.990.1993
service@ritmo.it
Disposal Do not dispose of in the household trash. Add the device that is no
longer able to be used to a separate collection for the purpose of
environmentally friendly recycling.
Publicidad
