Publicidad
Idiomas disponibles
Idiomas disponibles
Shower Ell
Apply
plumbers
putty.
Showerhead
(Not Provided)
1. Install the Shower Arm - Wall-Mount
NOTE: The showerhead is not provided.
Remove the temporary nipple from the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the wall flange according to the manufacturer's instructions.
Place the wall flange onto the long end of the shower arm just
below the threads, as illustrated.
Apply thread sealant tape to the threads of each end of the
shower arm.
Place the shower arm in the shower ell.
Carefully tighten the shower arm to the shower ell with a clean
strap wrench.
Press the wall flange against the finished wall. Setscrew in flange
should be facing towards the ceiling.
Secure the flange to the shower arm by tightening the setscrew.
Remove any excess putty.
Turn on the water and allow water to flow through the shower
arm to flush the system of any debris.
Turn off the water.
Install the showerhead according to the showerhead
manufacturer's instructions.
Check for proper operation.
Kohler Co.
Setscrew
Wall Flange
Shower Arm
Ball Joint
(Not Provided)
3
1065141-2-A
Publicidad
