Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
CARE AND CLEANING
For best performance and safety, keep the oven clean
inside and outside. Take special care to keep the inner
door panel and the oven front frame free of food or
grease build-up. Never use rough powder or pads.
Wipe the microwave oven inside and out, including the
hood bottom cover, with a soft cloth and a warm (not
hot) mild detergent solution. Then rinse and wipe dry.
Use a chrome cleaner and polish on chrome, metal and
aluminum surfaces. Wipe spatters immediately with
a wet paper towel, especially after cooking chicken
or bacon. Clean your oven weekly or more often, if
needed.
CLEANING THE GREASE
FILTER
To avoid risk of personal injury or property damage,
do not operate oven hood without filters in place.
The grease filter should be removed and cleaned often,
at least once a month.
1. To remove grease filter,
slide filter to the side. Pull
filter downward and push
to the other side. The filter
will drop out.
2. Soak grease filter in
hot water and a mild
detergent. Rinse well
and shake to dry. Do not
use ammonia or place
in a dishwasher. The
aluminum will darken.
3. To reinstall the filter, slide
it into the side slot, then
push up and toward oven
center to lock.
19
CAUTION
CHARCOAL FILTER
REPLACEMENT
If your oven is vented inside, the charcoal filter should
be replaced every 6 to 12 months, and more often
if necessary. The charcoal filter cannot be cleaned.
To order a new charcoal filter, contact the Parts
Department at your nearest Authorized Service Center
or call 1-800-843-0304 (inside U.S.A) or
1-866-587-2002 (Canada).
Order Charcoal Filter kit#: MVHRK4.
1. Unplug the oven or turn off power at the main power
supply.
2. Remove the two vent grille mounting screws.
(2 outer screws)
3. Tip the grille forward, then lift it out.
4. Open the door.
5. Push the hook and remove old filter.
Hook
6. Slide a new charcoal filter into place and close the
door. The filter should rest at the angle shown.
7. Slide the bottom of the vent cover into place.
Push the top until it snaps into place. Replace the
mounting screws. Turn the power back on at the
main power supply and set the clock.
Publicidad
