Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove 4 screws securing front panel.
2. Carefully slide front panel forward.
INSTALLING THERMOSTAT SENSING BULB ( OPTIONAL )
1. Carefully remove bulb clips with ther-
mostat sensing bulb from the shipping
position in the back panel.
2. Slide thermostat sensing bulb out of the
2 clips.
3. Carefully route thermostat sensing bulb
out of shipping position hole in the back
panel and into the relocation position hole.
If necessary, loosen wiretie securing capil-
lary. DO NOT kink capillary.
Bulb Clip
Mounting Bracket
The mounting bracket is located on back panel
of heater. It has been taped there for shipping.
Remove mounting bracket from back panel.
Methods For Attaching Mounting
Bracket To Wall
Use only the last hole on each end of mount-
ing bracket to attach bracket to wall. Attach
mounting bracket to a wall only in one of two
ways:
10
INSTALLATION
REMOVING FRONT PANEL
(For Heaters with Blower Installed Only)
Thermostat Sensing Bulb
Figure 6 - Moving Thermostat Sensing Bulb
FASTENING HEATER TO WALL
HearthSense
Front
Panel
Figure 5 - Removing Front Panel
4. Insert bulb clips into 2 rectangular slots
parallel to the bottom of heater (relocation
position). Slide thermostat bulb through
clips. If clips are damaged use clips lo-
cated in the hardware package.
Thermostat
Sensing
Bulb
Shipping
Location
Capillary
Thermostat Sensing Bulb Relocation Position
1. Attaching to wall stud: This method pro-
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
2. Attaching to wall anchor: This method
allows you to attach mounting bracket to
hollow walls (wall areas between studs)
or to solid walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
Screw
Route
Thermostat
Sensing
Bulb into
Hole
200549-02A
Publicidad
