Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE OF BLOWER MOTOR ( IF EQUIPPED )
Always disconnect the appliance from the
main power supply and allow it to cool
before any servicing operation.
The motors used on the fan heater and flame
blower are pre-lubricated for extended bear-
ing life and require no further lubrication.
However, periodic cleaning/vacuuming of the
appliance around the air intake and exhaust
WARNING: If you smell gas:
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone. Fol-
low the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
WARNING: Only a qualified service technician should service and
repair heater. Make sure that power is turned off before proceeding.
Turn off and let cool before servicing.
CAUTION: Never use a wire, needle, or similar object to clean
ODS/pilot. This can damage ODS/pilot unit.
IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning sup-
plies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc.,
create fumes. These fumes may mix with combustion air and create odors.
Note: All troubleshooting items are listed in order of operation.
Problem
Using natural gas and
pilot will not light.
Pressure Switch
When using natural gas, there is a pressure
switch that acts to turn off the gas flow to the
pilot if the inlet pressure exceeds 9.5" WC.
This is to prevent the operation of the unit
on the wrong gas (propane). If your natural
gas supply exceeds 9.5" WC the unit will
not operate. Either contact your gas supplier
to check and adjust the inlet pressure or a
qualified service technician can bypass the
pressure switch.
200549-02A
CARE AND MAINTENANCE
TROUBLESHOOTING
Possible Cause
I n l e t p r e s s u r e e x c e e d s
9.5" WC.
HearthSense
is recommended. For heavy or continuous
use, periodic cleaning must be done more
frequently. If the heater blows alternating cold
and warm air, check the fan for free movement
and for debris restricting air flow. If the fan
does not move freely, the unit must be turned
off and the fan replaced immediately in order
to prevent further damage to the unit.
Corrective Action
Bypass pressure switch. See
instructions below.
Before attempting to bypass the pressure
switch, make sure the type of gas being used
is correct. Check to make sure the connection
fitting is in the correct inlet on the regulator.
Refer to Connecting to Gas Supply, page 15.
23
Publicidad
