Publicidad
Idiomas disponibles
Idiomas disponibles
1. BLOWER SELECTION AND INSTALLATION
This product requires the addition of either an interior or exterior blower or in-line blower. The Best UP27 Series must be installed
with blower models iQ6, P3, P6, ILB3, ILB6, ILB9, ILB11, EB6, EB9, EB12 or EB15 only.
Other blowers cannot be substituted. (Blowers sold separately.)
Plan where and how the ductwork will be installed.
NOTE: There is no horizontal exhaust on UP27 Series range hood.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 to 5, 8, 10 to 12, 15 and up of
this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use metal duct tape to seal duct
joints.
NOTE: It is recommended that there be a minimum of 6" of straight duct from this hood to an elbow for 8" ducting and 12" for
10" ducting.
The minimum hood distance above cooktop must not be less than 24''. A maximum of 36" above cooktop is highly
recommended for best capture of cooking impurities. Distances over 36" are at the installer and users discretion.
EXTERIOR BLOWER
CABINET
HOOD
COOKING SURFACE
HH0219A
MODEL EB6, EB9, EB12 OR EB15
EXTERIOR BLOWER TYPICAL DUCTWORK
CABINET
8" ROUND ELBOW
HOOD
COOKING SURFACE
HH0218A
MODEL
Q6, P3 OR P6 INTERIOR BLOWER
i
10" ROUND DUCT
24" TO 36"
ABOVE
ROOF CAP
8" ROUND DUCT
24" TO 36"
ABOVE
TYPICAL DUCTWORK
(
EXCEPT
IN-LINE BLOWER
HH0220A
MODEL ILB3, ILB6, ILB9 OR ILB11
IN-LINE BLOWER TYPICAL DUCTWORK
5
WALL CAP
10" ROUND DUCT
ILB3, 8'' ROUND DUCT)
HOOD
24" TO 36"
ABOVE
COOKING SURFACE
ROOF CAP
WALL
CAP
Publicidad
