Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4° Visually inspect the spark plug.
Discard it if the insulator is cracked or
chipped. Clean the spark plug with a
wire brush if it is to be reused.
5° Measure the plug gap with a feeler
gauge. Correct as necessary by
carefully bending the side electrode.
The gap should be: 0.70 -0.80 mm
(0.028-0.031 in)
32
6° Check that the spark plug washer
is in good condition, and thread the
spark plug in by hand to prevent
cross-threading.
7° After the spark plug is seated,
tighten with a spark plug wrench to
compress the washer. If installing a
new spark plug, tighten ½ turn after
the spark plug seats to compress the
washer. If reinstalling a used spark
plug, tighten 1/8 – ¼ turn after the
spark plug seats to compress the
washer.
NOTICE: The spark plug must be
securely tightened. An improperly
tightened spark plug can become
very hot and could damage the
engine. Never use spark plugs which
have a improper heat range. Use only
the recommended spark plugs or
equivalent.
TRANSPORTING/STORAGE
When transporting the generator, turn
the engine switch and the fuel valve
OFF. Keep the generator level to
prevent fuel spillage. Fuel vapour or
spilled fuel may ignite.
WARNING: Contact with a hot
engine or exhaust system can cause
serious burns or fires.
Let the engine cool before
transporting or storing the generator,
Take care not to drop or strike the
generator when transporting.
Do not place heavy objects on the
generator.
Before storing the unit for an
extended period:
• Be sure the storage area is free of
excessive humidity and dust.
• Service according to the table on
next page:
Publicidad
