Ryobi P517 Manual Del Operador página 7

PLUNGE CUTTING
See Figure 7, page 9.
WARNING:
Make sure the blade does not touch work until motor
reaches full speed, since this could cause loss of control
resulting in serious injury.
WARNING:
Blades longer than 6 in. can whip and should not be used
for plunge cutting. Failure to heed this warning can result
in serious personal injury.
 Choose a convenient starting point inside the cutting area
and place the tip of the blade over that point.
 Rest the front edge of the shoe assembly on the workpiece
and hold it firmly in position during the cut.
 Slide the lock-off button to the unlocked position and
depress the switch trigger.
 Allow the saw blade to reach full cutting speed.
 Tilt the saw downward until the tip of the blade starts
cutting the workpiece.
 Allow the blade to penetrate the workpiece.
 Tilt the saw until the blade is perpendicular to the
workpiece.
WARNING:
When servicing use only identical replacement parts. Use
of any other parts can create a hazard or cause product
damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
OPERATION
Cutting into electrical wiring can cause the blade, the
blade clamp, and the saw bar assembly to become elec-
trically live. Do not touch metal parts when cutting into a
wall; grasp only the insulated surfaces on the tool. Make
sure hidden electrical wiring, water pipes, and mechanical
hazards are not in the blade path when cutting into a wall.
METAL CUTTING
See Figure 8, page 9.
You may cut metals such as sheet steel, pipe, steel rods,
aluminum, brass, and copper with the saw.
Observe the following tips when metal cutting:
 Be careful not to twist or bend the saw blade.
 Do not force the tool and use a slow speed.
 Use cutting oil when cutting soft metals and steel. Cutting
oil also keeps the blades cool, increases cutting action,
and prolongs blade life.
 Never use gasoline since normal sparking of motor could
ignite fumes.
 Clamp the workpiece firmly and cut close to the clamping
point to eliminate any vibration of the work. When cutting
conduit pipe or angle iron, clamp the workpiece in a vise
if possible and cut close to the vise. To cut thin sheet
material, "sandwich" the material between hardboard or
plywood and clamp the layers to eliminate vibration and
material tearing.
 Always keep firm pressure on the shoe assembly to hold
it securely against the workpiece.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
NOTE: ILLUSTRATIONS START ON
7 – English
WARNING:
WARNING:
PAGE 8 AFTER
FRENCH AND SPANISH
LANGUAGE SECTIONS.