YATO YT-82836 Manual De Instrucciones página 22

GB
Attention! If, when the charger is connected to the power supply, the green LED is on, this indicates a fully charged battery. In this
case, the charger does not start charging.
MAINTENANCE AND STORAGE OF THE PRODUCT
Attention! Before starting any operation, which is described below, you should disconnect the pole pruner from the power supply.
The tool, which is mains powered, should be disconnected from the wall outlet, the tool, which are battery operated, should be
disconnect from the battery.
After each use, you should examine your tool condition with particular emphasis on the patency of the ventilation openings.
Check the alignment of all elements of the tool. Any loose connections should be tightened. Check the voltage and condition of
the chain. If you notice any chain damage, the chain should be replaced with a new one. It is forbidden to operate the pole pruner
with a damaged chain!
Too loose chain may fall out from its guide, which can cause injuries to the operator. The chain must also be properly sharpened,
because it requires the relevant experience and tools, it is recommended, to perform chain sharpening in a specialist service. You
should fi ll up the oil defi ciencies in the tank. The tool housing should be cleaned with a soft dry cloth. Clean the housing of residual
wood, oil, grease and other contaminants. The tool should be stored in a dry, closed room, disconnected from the mains.
Attention! During the tool storage, it can produce a small amount of oil from the chain lubrication system, this is normal and does
not aff ect the oil level in the tank and is not a sign of failure.
The tool should be stored in the areas, which are shaded, dry, and equipped with adequate ventilation to prevent condensation.
The place should not be available for bystanders, especially children. During storage the guide and chain should always be
protected by the cover.
O R I G I N A L I N S T R U C T I O N S
22