Publicidad
Idiomas disponibles
Idiomas disponibles
INITIALIZING & PROGRAMMING THE AX-GMCL2-SWC
For the steps below, the Red L.E.D. (located inside the interface, next to the potentiometer)
can only be seen while active. The interface does not need to be opened to see the L.E.D.
This is a timed process, so it would be best to read these steps beforehand, to ensure a clear
understanding of what is to be expected.
1. Turn the key (or push-to-start button) to the ignition position, the L.E.D. will turn on.
2. Within a minute, the L.E.D. will turn off for a couple seconds, then flash slowly (up to (18)
times, indicating which radio is connected to the interface), and then turn off. Pay close
attention as to how many slow flashes there are. This will help in troubleshooting, if need
be. Refer to the L.E.D. feedback section for more information.
3. Within a few seconds the L.E.D. will turn on, and the radio will turn off.
4. Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the
initialization process is successful.
Note: If the radio does not come back on within a minute, the interface is not communicating to
the vehicle. Turn the key off, check all connections, and then try again. The interface may need
to be reset at this point.
5. Immediately after the L.E.D. turns off, and the radio comes back on, the following buttons
on the steering wheel must be pressed in the exact sequence as shown. For each button
press, the L.E.D. will turn on momentarily:
• Volume Up
• Seek Up
• Volume Up
• PTT (OnStar) or MUTE
• Volume Up
6. The L.E.D. will turn on after the last Volume Up button has been pressed, indicating
programming has ended.
7. Press all the buttons to ensure that they are working as intended.
8. Cycle the ignition and test again.
9. If any steps in this process failed, or was executed improperly, reset the interface, and then
resume from step 5.
Notes:
• PTT (OnStar) when pressed will Mute/Attenuate the radio.
• PTT (OnStar) when pressed and held for 2 seconds will activate OnStar, if applicable.
For all other applications:
For the steps below, the Red L.E.D. (located inside the interface, next to the potentiometer) can
only be seen while active. The interface does not need to be opened to see the L.E.D.
1. Turn the key (or push-to-start button) to the ignition position, the L.E.D. will turn on.
2. Within a minute, the L.E.D. will turn off for a couple seconds, then flash slowly (up to (18)
times, indicating which radio is connected to the interface), and then turn off. Pay close
attention as to how many slow flashes there are. This will help in troubleshooting, if need
be. Refer to the L.E.D. feedback section for more information.
3. Within a few seconds the L.E.D. will turn on, and the radio will turn off.
4. Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the
initialization process is successful.
Note: If the radio does not come back on within a minute, the interface is not communicating to
the vehicle. Turn the key off, check all connections, and then try again. The interface may need
to be reset at this point.
(CONT)
REV. 7/24/2017 INSTAX-GMCL2-SWC
7
Publicidad
