Publicidad
Idiomas disponibles
Idiomas disponibles
34 OPERATION
Setting the Meat Probe Function (example: Conv.
Roast at 350°F with probe temp at 160°F)
1
Select cook mode. Turn the oven mode knob to
select Conv. Roast.
2
Set the oven temperature: press plus(+) or
minus(-) until 375
°F
appears in the display.
3
Press Start.
4
Set the probe temperature: press plus(+) or
minus(-) until 160
°F
appears in the display.
5
Press Start.
The default probe temperature is 150 °F (65 °C), but
can be changed to any temperature between
80 °F (27 °C) and 210 °F (100 °C). The display
shows the changing probe temperature. When the
set probe temperature is reached, the oven shuts off
automatically.
Changing the Probe Temperature while Cooking
1
Press Temp.
2
Set the oven temperature and probe temperature.
3
Press Start.
IMPORTANT NOTE
Press Clear/Off to cancel the Meat Probe function
at any time. To avoid breaking the probe, make sure
food is completely defrosted before inserting.
CAUTION
Always use an oven mitt to remove the
temperature probe. Do not touch the broil
element. Failure to obey this caution can result
in severe personal injury.
To avoid damage to the meat probe, Do
not use tongs to pull on the probe when
removing it.
Do not store the meat probe in the oven.
Recommended Probe Temperature Chart
Doneness
Beef, Lamb and Veal
Rare
Medium Rare
Medium
Well Done
Pork
Well Done
Poultry
Breast, Well Done
Thigh, Well Done
Stuffing, Well Done
Remote Start
If the appliance is registered on a home Wi-Fi
network, this function starts preheating and then
holds the temperature for up to an hour (including
preheating time). If the appliance is not registered on
the network, "OFF" appears in the display. Follow the
instructions on page 35 to register the appliance on
the network.
Set the oven mode knob to the Remote Start position
to use the function.
Setting Remote Start
1
Open the oven door to make sure the oven is
empty and ready for pre-heating. Close the oven
door.
2
Within 30 seconds of closing the door, turn the
oven mode knob to Remote Start to use the
function. If more than 30 seconds passes before
you initiate Remote Start, "door" appears in the
display. If this occurs, open and close the door
and try again.
3
When ON appears in the display, the Remote
Start function is ready to use.
4
Follow the directions in the smart phone
application to set the cook mode, temperature,
and run time (preheating time plus holding time).
NOTE
Do not place food in oven before or during
Remote Start run time.
Remote Start is disconnected in the following
situations:
Remote Start is never set up in the smart phone
Probe Temp.
app.
The Remote Start status is "OFF" or "door".
130 °F (54 °C)
Remote Start experiences a problem during
140 °F (60 °C)
operation.
150 °F (66 °C)
160 °F (71 °C)
The Remote Start function cannot be started
when the oven door is open. A beep alerts you
to shut the door.
170 °F (77 °C)
170 °F (77 °C)
180 °F (82 °C)
165 °F (74 °C)
Publicidad
