Publicidad
Idiomas disponibles
Idiomas disponibles
My range is still dirty after running the
®
EasyClean
cycle. What else should I do?
®
The EasyClean
cycle only helps to loosen light soils
in your oven range to assist in hand-cleaning of your
oven. It does not automatically remove all soils after
the cycle. Some scrubbing of your oven range is
required after running the EasyClean
I tried scrubbing my oven after running EasyClean
but some soils still remain. What can I do?
®
The EasyClean
feature works best when the soils
are fully soaked and submerged in water before
running the cycle and during hand-cleaning. If soils
are not sufficiently soaked in water, it can negatively
affect the cleaning performance. Repeat the
®
EasyClean
process using sufficient water.
Sugar-based and certain greasy soils are especially
hard to clean. If some stubborn soils remain, use the
Self Clean feature to thoroughly clean your oven.
Soils on my oven walls are not coming off. How
can I get my walls clean?
Soils on the side and rear walls of your oven range
may be more difficult to fully soak with water. Try
®
repeating the EasyClean
process with more than
the ¼ cup (2 oz or 60 ml) spray recommended.
®
Will EasyClean
get all of the soils and stains out
completely?
It depends on the soil type. Sugar-based and certain
grease stains are especially hard to clean. Also, if
stains are not sufficiently soaked in water, this can
negatively affect cleaning performance.
If stubborn or built-up stains remain, use the Self Clean
feature. Refer to the Self Clean section of your owner's
manual.
Are there any tricks to getting some of the
stubborn soils out?
Scraping the soils with a plastic scraper before
and during hand-cleaning is recommended. Fully
saturating soils with water is also recommended.
However, certain types of soils are harder to clean
than others. For these stubborn soils, the Self Clean
cycle is recommended. Consult the Self Clean section
of your owner's manual for details.
Is it safe for my convection fan, broil burner or
heater element to get wet during EasyClean
Yes. The convection fan, broiler burner or heater
element may get a little wet during cleaning. However,
direct spray onto the broil burner and heater elements
is not necessary because these are self-cleaning
®
cycle.
during regular use.
®
,
Do I need to use all 1¼ cups (10 oz or 300 ml) of
water for EasyClean
Yes. It is highly recommended that 1 cup (8 oz or
250 ml) of water be sprayed or poured on the bottom
and an additional ¼ cup (2 oz or 60 ml) of water
be sprayed on walls and other soiled areas to fully
saturate the soils for better cleaning performance.
I see smoke coming out of my oven range's
cooktop vents during EasyClean
This is normal. This is not smoke. It is actually water
vapor (steam) from the water in the oven cavity. As
the oven heats briefly during EasyClean
in the cavity evaporates and escapes through the
oven vents.
How often should I use EasyClean
EasyClean
EasyClean
soiled from such things as LIGHT grease splatter
and small drops of cheese. Please refer to the
EasyClean
information.
What is required for EasyClean
A spray bottle filled with 1¼ cups (10 oz or 300 ml) of
water, a plastic scraper, a non-scratch scrubbing pad
and a towel. You should not use abrasive scrubbers
such as heavy-duty scouring pads or steel wool.
Except for a towel, all of the materials you need are
included in a special cleaning kit with your new range.
Can I run the EasyClean
ovens at once?
Yes. You can run the EasyClean
ovens at the same time. Some oven surfaces will be
hot after the cycle completes running. Avoid leaning
or resting on the oven door glass while cleaning the
oven cavities.
You cannot run the Self Clean cycle on both ovens at
the same time.
TROUBLESHOOTING
®
?
®
. Is this normal?
®
®
can be performed as often as you wish.
®
works best when your oven is LIGHTLY
®
section in your owner's manual for more
®
?
®
cycle on both of my
®
cycle on both
49
®
?
®
, the water
?
Publicidad
