Publicidad
Idiomas disponibles
Idiomas disponibles
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
Do not trim the grass or weeds while using hedge
•
shear blade. The shear blade may entangle the
grass or weeds.
010879
Hold the trimmer with one hand, depress the lock-off
button and pull the switch trigger and then move it in front
of your body.
1
3
010880
As a basic operation, tilt the blades towards the trimming
direction and move it calmly and slowly at the speed rate
of 3 - 4 seconds per meter.
010881
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
1. Trimming
direction
2. Tilt the blades
3. Hedge surface to
be trimmed
2
1. String
1
010966
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
010967
To cut a hedge side evenly, it helps to cut from the bottom
upwards.
010968
Trim boxwood or rhododendron from the base toward the
top for a nice appearance and good job.
Installing or removing chip receiver
(accessory)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing chip receiver.
NOTE:
When replacing the chip receiver, always wear
•
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
When replacing the chip receiver, always be careful
•
not to contact the shear blades.
The chip receiver receives cut-off leaves and
•
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
16
Publicidad
