Master Appliance UT-100Si Manual De Instrucciones página 6

How to Empty Tank of Butane Gas if Needed
1. Only empty fuel tank in a well ventilated
area and away from ignition sources.
Remember butane is heavier than air.
2. Depress the filler valve at the back of the
tank with a small bladed screwdriver and
let the butane gas escape through the
small orifice opening. It takes approxi-
mately one minute for the butane to
escape from the tank. Be careful that the
butane does not hit against your fingers
or hands. This could cause frostbite of
the skin.
Ultratane™ Butane
"ULTRA-REFINED" by Master...the only approved butane for Ultratorches.
• Single piece universal tip
• Purest refining method possible
• Special non-clogging formula to permit extended use
Storage of Your Ultratorch Heat Tool
1. Allow unit to cool and put protective cap on for storage.
2. If your unit is not going to be used for awhile, store in the following manner: Store in proper
location avoiding elevated temperatures and away from children.
3. Leave tank approximately 1/2 full so lubrication of fuel pickup filter stays wet.
4. Set flow control valve at setting 5.
3. One method is to poke a small bladed
screwdriver through a piece of paper
and then carefully depress the filler
valve. The escaping gas will hit the
paper and not your hand.
4. Never turn gas lever to "ON" and allow
gas to evacuate through the ejector/tip.
Doing this will clog the ejector and lead
to premature failure.
5. Never try to unscrew the filler valve
as it is adhesively bonded to the tank.
Breaking of this bond will destroy the
unit, causing the tank to leak.
P/N 51773 - 5.125 oz.
P/N 10448 - 26gm. canisters