Troubleshooting - Master Appliance UT-100Si Manual De Instrucciones

Specifications
Overall length with soldering tip
Overall length with heat tip
Weight (when gas filled)
Approximate temp. soldering tip
Approximate temp. heat tip
Gas Capacity Container
Approximate Operating Time
(one gas filling)
Trouble Shooting
Problem
Does not ignite
Low gas pressure
Low flame
Not enough heat
Note: Ultratorches utilize the energy produced while evaporating butane gas. Ambient
temperature affects operation. Adjust the unit as necessary.
Probable cause
a. Empty tank
b. Clogged ejector
c. Fuel setting too high
a. Foreign object blocking tips
b. Cold fuel
a. Used-up catalyst
b. Low fuel
UT‑100Si
262mm (10.3 in.)
247mm (9.7 in.)
126g (5.4 oz.)
250° - 500°C
(507° - 958°F)
650°C (1228°F)
28cc (1.6 cu. in.)
Max. 2 hours
at #3 setting
a. Refill with butane fuel
b. Replace with new ejector
c. Adjust switch ring or gas
control lever to lower setting
a. Clean out or replace tips
b. Hold unit in hand to allow unit
to warmup.
DO NOT HEAT HANDLE.
a. Replace with new tip
b. Refill with butane gas
UT‑200Si
302mm (11.9 in.)
285mm (11.2 in.)
222g (9 oz.)
250° - 530°C
(482° - 986°F)
540°C (1030°F)
63cc (3.8 cu. in.)
Max. 4.5 hours
at #3 setting
Solution