Publicidad
Idiomas disponibles
Idiomas disponibles
- Clear lamp time
• With this function you can clear the running time of the lamp. Please clear the lamp time every time you
replace the lamp.
• Select "CLLT" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DN] to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 5
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] to select "EDIT".
- Define the number of steps in Run
With this function you can define the number of steps in the Program Run.
• Select "STEP" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"S-XX", "X" stands for the total amount of steps you want to
save, so you can call up to 48 scenes in "RUN". For example if the "XX" is 05, it means that "RUN" will run
the first 5 scenes you saved in "EDIT".
• Press [MODE/ENTER] to save and exit.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in Run.
under "STEP" and the scenes can be called up under "RUN"
a) Editing via the Control Board
• Select "SC01" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "SCXX", "X"
stands for the scene no. to be edited.
• Change the scene no. by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "C-XX", "XX"
stands for the channel no. Such as "C-01", it means you
are editing channel 1 of the selected scene.
• Select the channel no. you would like to edit by pressing
[UP].
• Press [MODE/ENTER] to enter editing for the selected
channel , the fixture reacts to your settings. The display
shows the DMX value of the edited channel. Such as "
11XX", it stands for channel 11 of the current scene, the
DMX value is XX , XX is a hexadecimal number value "01-
FF".
• Adjust the desired DMX value by pressing [UP] or [DN].
• Press [MODE/ENTER] in order to edit other channels of
this scene.
• Repeat above steps until you finish setting all the DMX
values for all channels of this scene.
• Once all the channels completed, the display will flash
"tIME".
• Press [MODE/ENTER] to edit the time needed, the
display shows "t--X","X" stands for the time needed to run
the current scene, value "1-9". For example, "t--2" means
you need 2 seconds to run the current scene.
• Adjust the desired time by pressing [UP] or [DN].
• Press [MODE/ENTER] to save the settings for the scene
you are editing, the display will change to the next scene
automatically.
• Repeat above steps to edit and other scenes, you can
edit and save a maximum of 48 scenes.
• Press [EXIT] to exit. The number of steps can be defined
50/104
00026934.DOC, Version 1.6
Publicidad
