Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
7. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on the
surface.
m
CAUTION!
Damage may occur to painted surfaces if the
detergent is allowed to dry on the surface. Wash and rinse a
small section at a time. Avoid working on hot surfaces or in direct
sunlight.
8. When finished using the pressure washer, you must first drain
and rinse the foam cannon bottle. Run the pressure washer
until all of the soap is drained from the foam cannon bottle.
m
CAUTION!
Failure to follow these cleaning instructions will
cause the injection system to become clogged and inoperable.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage
the cleaning surface.
Installing The Rotating Surface Cleaner
(SPX-PCA10) (Fig. 22)
1. Fit the second piece of the cleaning attachment into top slots
of surface cleaner.
2. Flip the cleaning brush over to its bottom side and align the
dual rotating spray nozzles with the second piece of the
cleaning brush.
3. Once aligned, twist the locking collar on the dual rotating
spray nozzles clockwise to lock into place.
Fig. 22
Dual rotating
brush nozzles
Second piece
Surface cleaner
12
Using The Rotating Surface Cleaner
1. If not already done, detach your spray wand from your trigger
gun.
2. Take the longer end of your surface cleaner assembly and
align the two tabs with the trigger gun (Fig. 23).
Fig. 23
Surface cleaner
assembly
3. Once aligned, push the top piece into the trigger gun, twist
counter clockwise to lock into place (Fig 23).
Shutting down
1. Turn the switch to the OFF (0) position and unplug the power
cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the trigger
gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock on the back.
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Storage
m
CAUTION!
Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
Trigger gun
Tabs
Publicidad
