Descargar Imprimir esta página

Greencut GTC190X Manual De Instrucciones página 62

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

62
The following information will help you to make the necessary revision and to carry out the required procedures to
follow the recommendations of the normal maintenance of your motor hoes.
MOTOR OIL
ATTENTION: The machine is supplied without oil. Fill the tank before starting it up.
1.
Clean oil dipstick.
2.
Put the dipstick into the oil filler neck and screw it on.
3.
If the level is low, fill the recommended oil to the center of the dipstick.
AIR FILTER
Check that the air filter is not dirty or clogged. To clean it, follow the steps below:
1.
Remove wing nut and air filter cover.
2.
Clean the filter with soapy water.
3.
Rinse the filter with plenty of clean water
4.
Immerse the filter in clean engine oil and squeeze out the excess.
5.
Replace the filter.
CHECK THE TRANSMISSION GREASE
The transmission grease should be checked every 24h of use. To check the grease:
1.
Remove the left blades.
2.
Remove the upper and lower grease plugs.
3.
lace grease with a hand grease pump in the lower hole until clean
grease comes out of the upper hole or vice versa.
YOU CAN REVIEW THE EXPLANATORY VIDEO BY SCANNING THE FOLLOWING QR:
FUEL
ATTENTION: Do not overfill the fuel tank (there should be no fuel in the filler neck).
Fill the fuel tank in a well-ventilated area with the engine stopped. Do not smoke or allow flames or sparks to
occur in the area where the engine is refuelled or gasoline is stored.
After refueling, make sure the fuel filler cap is properly and securely closed.
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite. If fuel is spilled, make sure the
area is dry before starting the engine.
Avoid repeated or prolonged contact with skin or breathing vapors.
Cleaning the fuel filter cup and O-ring:
1.
Remove the filter cup and O-ring.
2.
Wash with solvent
3.
Dry and reposition safely.

Publicidad

loading