Descargar Imprimir esta página

Greencut GTC190X Manual De Instrucciones página 63

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
Engine does not
start
The engine runs
irregularly during
operation:
Engine is hard to
start:
The engine lacks
power:
The engine does
not stop when the
control is in the
"stop" position:
Handlebars move
forward during
ignition:
Blades do not
rotate:
Add fuel to the tank
Connect spark plug wire
the throttle must be in the START position for a cold start.
Clean and maintain the carburetor and its internal components.
Make sure that the fuel is not more than 15 days old.
Clean or replace the air filter
Perform cleaning and maintenance of the carburetor and its internal
components.
Make sure that the fuel is not more than 15 days old.
Drain the old fuel and replace it with new fuel.
Make sure that the spark plug wire is perfectly connected.
The safety control levers must be in a neutral position to start the engine.
Perform cleaning and maintenance of the carburetor and its internal
components.
Make sure that the fuel is not more than 15 days old.
Raise the cutters to till shallower (by means of depth regulator).
Remove and clean the fuel tank
Clean or replace the air filter
Carburetor adjustment is incorrect, take engine for service
Replace spark plug and adjust clearance
Drain and refill the fuel tank and carburetor.
Perform cleaning and maintenance of carburetor and internal components
Make sure that the fuel is not more than 15 days old.
Check and adjust throttle
Safety control levers must be in neutral position to start the engine.
It is difficult to control the handlebars when tilling:
Put the wheels in tilling position.
Raise cutters for shallower tilling.
Check belt tensionCheck that the belt has not come off the pulleys.
Replace the complete drive
SOLUTION
63
EN

Publicidad

loading