Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy
with the screw in the mounting bracket. Push
up to engage the slots and turn clockwise
to lock in place. Immediately tighten the
mounting screw firmly.
2. Install the remaining mounting screw into
the canopy and tighten firmly.
3. Install the canopy bottom cover by aligning
the slots in canopy bottom cover with the
screws in the canopy. Rotate the canopy
bottom cover clockwise to lock in place.
4. You may now proceed to attaching the
fan blades.
7.
Attaching the Fan
Blades
1. Align the three screw holes in the blade
with the screw holes in the blade arm
and secure with the screws provided.
(Figure 11)
2. Repeat for the remaining blades.
Blade Balancing
All blades are grouped by weight. Because
natural woods vary in density, the fan may
wobble even though the blades are weight
matched.
The following procedure should correct most
fan wobble. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
from a point on the center of each blade
to the point on the ceiling. Measure this
distance as shown in Figure 12. Rotate
the fan until the next blade is positioned
for measurement. Repeat for each blade.
Measurements deviation should be within
1/8". Run the fan for 10 minutes.
3. Make sure that canopy is tightened securely
to ceiling mounting bracket and that the
ceiling mounting bracket is tightened
securely to the electrical box.
4. Interchanging two adjacent blades can
redistribute the weight and possibly result
in the smoother operation.
5. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
Flywheel
Touching
Ceiling
Screws
Blade
Blade arm
Figure 11
Figure 12
Publicidad
