Publicidad
Idiomas disponibles
Idiomas disponibles
Hanging the Fan
REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE: This fan is recommended for
standard ceiling mount using the downrod
provided with this fan. When using standard
ceiling installation with the 6 inch downrod
provided, the distance from the ceiling
to the bottom of the fan blades will be
approximately 13 inches.
Standard Ceiling Mounting
1. Remove the canopy bottom cover from
the canopy by turning the canopy bottom
cover counter-clockwise until it unlocks.
(Figure 5)
2. Remove the non-slotted screw and loosen
but do not remove the slotted screw. This
will enable you to remove the mounting
bracket from the canopy. (Figure 6)
3. Remove the hanger pin and locking pin
from downrod assembly.
4. Route the wires exiting the top of the fan
motor through the decorative motor collar
cover then the center of the canopy bottom
cover. Make sure the slot opening are on
top. Route the wires through the canopy and
then through the ball/downrod assembly.
(Figure 7)
Turn Canopy bottom cover to Remove
Canopy bottom cover
Loosen but
do not remove
5. Loosen, but do not remove, the set screws on
the collar on the top of the motor housing.
6. Align the holes at the bottom of the downrod
with the holes in the collar on top of the
motor housing. (Figure 7) Carefully insert
the hanger pin through the holes in the
collar and downrod. Be careful not to jam
the hanger pin against the wiring inside the
downrod. Insert the locking pin through the
hole near the end of the bolt until it snaps
into its locked position, as noted in the circle
inset of Figure 7.
7. Re-tighten the set screws on the collar on
top of the motor housing.
Canopy
8. Make sure the grommet is properly installed
in the collar cover, then slide the collar cover
on the downrod until it rests on the motor
housing. Be sure that the canopy and the
collar cover are both oriented correctly.
9. Proceed to "Installing the Fan" section.
Figure 5
FAILURE TO PROPERLY INSTALL SET SCREWS
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Ball/Downrod
assembly
Canopy
Remove
Canopy
Figure 6
bottom cover
Motor collar
cover
Hanger pin
Motor
collar
Reverse
switch
Motor wires
Pin in
locked
position
Tighten screws
Locking
pin
Figure 7
4.
Publicidad
