Aspes AIFZ5600 Manual De Instrucciones página 27

Cautions
 The hob must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
 The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
 The hob shall be installed such that better heat radiation can be ensured to enhance
its reliability.
 The wall and induced heating zone above the work surface shall withstand heat.
 To avoid any damage, the sandwich layer and adhesive must be resistant to heat.

A steam cleaner is not to be used.
 This ceramic can be connected only to a supply with system impedance no more
than 0.427 ohm. In case necessary, please consult your supply authority for system
impedance information.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown below.

If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.

If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.

The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.

The cable must not be bent or compressed.

The cable must be checked regularly and only replaced by a proper qualified
person.
AIFZ5600 AI3600SB/AI3600
27