Descargar Imprimir esta página

Simpson MS60809-S Manual De Instrucciones página 8

Ocultar thumbs Ver también para MS60809-S:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING: To reduce the risk of injury, read the pressure washer instruction
manual and the engine instruction manual before operating pressure washer.
Install the
A
Handle
Place handle
onto frame, depress the
snap buttons, and slide
the handle assembly
onto the frame until snap
buttons snap into place.
IMPORTANT: Ethanol Shield
and prevent ethanol related problems in power equipment. Follow the instructions on
the container and add to the gasoline.
DANGER:
• Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly gas.
• Risk of fluid injection and laceration. When using the high pressure setting, DO
NOT allow the high pressure spray to come in contact with unprotected skin, eyes
or with any pets or animals. Serious injury will occur.
WARNING: Do not allow the unit to run for more than two minutes without the
gun trigger being pulled. This could cause overheating and damage to the pump.
When the temperature inside the pump rises too high, the thermal relief valve will
open and release a spray of water from the pump to lower the internal tempera-
ture. The valve will then close.
Connect Garden
1
Hose to Pump
Thread
the garden hose to
the pump inlet.
See Label #1 on the
back of the unit.
QUICK SETUP GUIDE
Add/Check Oil
B
The engine is
shipped without
oil. Before starting engine,
add the oil. Check oil level
prior to each use. Refer to
Engine Owner's Manual
for complete procedure.
(sold separately) is a fuel stabilizer that helps eliminate
TM
QUICK START GUIDE
Connect High
2
Pressure Hose
to Pump
Thread the high pressure
hose to the pump outlet.
See Label #2 on the
back of the unit.
8- ENG
Add Gasoline
C
In a well
ventilated outdoor
area add fresh, high
quality, unleaded gasoline
with a pump octane rating
of 86 or higher. Do not
overfill. Wipe up spilled
fuel before starting the
engine. Refer to Engine
Owner's Manual for
complete procedure.
Connect High
3
Pressure Hose
to Spray Gun
Thread the other end
of the high pressure
hose to the spray gun.

Publicidad

loading