Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Spray
4
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
Release Air from
7
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30 seconds.
Verify the Choke
10
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
See Label #10 on the
side of the engine.
WARNING: This Guide is not a substitute for reading the operator's manual. User
must read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect cou-
pler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the Fuel
8
Valve is turned
to the OPEN
Position
The Fuel Valve has been
preset by the factory to
be in the OPEN position.
See Label #8 on the
side of the engine.
Pull the Recoil
11
Starter Grip
Pull the
recoil starter grip to
start the engine.
See Label #11 on the
side of the engine.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Engine
9
Switch is turned
to the ON
Position
See Label #9 on the
side of the engine.
Push the Choke
12
Pin to the OPEN
Position
Gradually move the
Choke Pin to the
OPEN Position after
engine starts.
See Label #12 on the
side of the engine.
Publicidad
