Install The Rough-In Plate To The Hood; Connect The Wiring; Install The Blower - Best WP29M Serie Manual De Instalación

11. INSTALL THE ROUGH-IN PLATE TO THE HOOD

11.1 A I
LL NSTALLATIONS
Run power cable to installation location. Refer to the instructions included with
the selected blower/rough-in kit (sold separately) for details on installing the
rough-in plate. Install the rough-in plate so that the wiring box is located on the
right side as you are facing the hood.
11.2 D I
UCTED NSTALLATIONS ONLY
For ducting through back of hood, remove existing plate from inside back of
hood and attach it to inside top of hood to cover hole. Secure to threaded studs
with same (4) nuts. For ducting through top of hood, existing plate remains in
place on inside back of hood.
Connect ducting to adapter and damper or rough-in plate (according to blower
model) as you are installing the rough-in plate. Use duct tape to make all joints
secure and air-tight.

12. CONNECT THE WIRING

Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Remove wiring cover from rough-in plate and set aside.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw.
Reinstall wiring cover.

13. INSTALL THE BLOWER

Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle
and the power supply cord (B) onto the male connector inside the hood.
Do not plug the two cords into each other.
14. INSTALL THE CALIBRATION BUTTON BRACKET IN THE HOOD
(iQ6 AND iQ12 INTERIOR BLOWERS ONLY)
Both iQ6 and iQ12 blowers are equipped with a calibration button already mounted to its own bracket.
Install this bracket in the hood, using 2 screws provided with iQ6 or iQ12 interior blower.
See additional details in the iQ6 and iQ12 blower instructions included with the blowers.
:
:
(ALL INSTALLATIONS)
(INTERIOR OR EXTERIOR BLOWER)
WARNING
!
(ALL INSTALLATIONS)
WARNING
!
HE0078
9
R -
OUGH IN PLATE
ON TOP OF HOOD
L
OCKNUTS
L
OCKNUTS
P
LATE ON BACK OF HOOD
HD0179
A B
HD0539
W
IRING COVER