Install The Rough-In Plate To The Hood; Connect The Wiring - Best UP27M Serie Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. INSTALL THE ADAPTER/DAMPER TO ROUGH-IN PLATE
(iQ6, P3 AND P6 BLOWERS, DUCTED INSTALLATION ONLY)
Attach 8" round adapter and damper to iQ6, P3 or P6 blower rough-in plate.
Use metal duct tape to make all joints secure and air-tight.

10. INSTALL THE ROUGH-IN PLATE TO THE HOOD

Run power cable to installation location. Refer to the instructions included
with the selected blower/rough-in kit (sold separately) for details on
installing the rough-in plate. Attach blower plate to the studs at the inside,
top of hood with 4 no. 10-32 nuts, provided. Install the rough-in plate so
that the wiring box is located on the right side as you are facing the hood.

11. CONNECT THE WIRING

Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Remove wiring cover from rough-in plate and set aside.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw.
Reinstall wiring cover.
12. INSTALL THE HOOD
Place the hood at its location. Using a pen, mark the position of the screws (smaller part of the keyholes [A]). Remove the hood and install
(4) 1/2" double thread screws at marked positions, leaving a 1/8" gap.
Place the hood under the cabinet and slide it in position. Make sure the adapter/damper enters the ducting and the damper opens freely
(internal blower only), or ensure ducting connects to rough-in plate (exterior or in-line blower only). Secure the hood by tightening the
screws completely. Install the last 1/2" double thread screws in the remaining holes (B).
(ALL BLOWERS)
A
B
HD0116
(ALL BLOWERS)
B
P
LOWER
LATE
HD0048
WARNING
!
8
HO0196
N
.10-32
O
(2
PER SIDE
NUTS
)

Publicidad

Tabla de contenido
loading

Tabla de contenido