Plein Air CM-TN2000 Manual De Instrucciones página 12

10. This appliance is exclusively designed for indoor uses.
11. Do not place the appliance directly below a power socket.
12. This equipment should not be operating without
monitoring.
13.
CAUTION - Some parts of this product can become very
hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
1. Remove all the packaging material and make sure that the appliance is in good condition. If you
have any doubt, do not use the appliance and contact our After-Sales Service. Keep the packaging
material (staples, nylon bags, etc.) out of the reach of children. Before turning the appliance on,
check that the voltage and frequency of the power socket are compatible with those indicated in
the product technical plate.
2. This appliance must be connected to an approved mains socket that complies with the safety
regulations on electrical systems for civil purposes. The electrical system must be specific for the
appliance rated voltage and must be equipped with an earth cable.
3. The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any
use other than its intended purpose shall be deemed to be improper and hazardous.
4. The manufacturer shall not be held responsible for damages derived from misuse of this appliance,
do not assuming any responsibility in case of incorrect use that will decline any warranty.
5. Always place the fan heater on a flat and even surface, it should not be exposed to vibration or
mechanical stress.
6. The appliance must be placed at a minimum distance of 50 cm from any combustible materials as
furniture, pillows, bedding, paper, clothes, curtains, plants, etc.
7. In order to have a good air aspiration and to avoid damaging of the product, maintain the air inlet
and outlet free from objects.
8. The appliance has dangerous components that must be kept out of the reach of children.
9. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord.
Before any maintenance operations, disconnect the plug from the mains socket.
10. The power cord must never be in contact with the hot surfaces of the appliance.
11. Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar
elements. Pay attention not to place the power cable where it is likely to get into people's way.
12. If the appliance does not work properly, immediately turn it off and disconnect it from the mains
socket. For repairs, contact a technical support center authorized by the manufacturer, and require
that original spare parts be used. Using parts that do not conform to the product may seriously
compromise its correct operation.
13. In order to unplug the appliance, select "0" and disconnect the plug from the power socket.
INSTRUCTIONS FOR USE
Thermostat and power
1
Knob
Power light
2
Auto swing switch (back
3
of the appliance)
4 Air outlet
5 Base
DT Istr (CM-TN2000) 02/20 – Rev.0_02/20
GENERAL WARNINGS
CM-TN2000
12/24