Publicidad
Idiomas disponibles
Idiomas disponibles
"REFILL WHEN LIT" INDICATOR (
refilling. See the section "Filling the Water Tanks". If still illuminated a few minutes after
full tank is placed on base, reposition water tanks. (Unit will operate with only one
water tank.) Each time you fill tanks, rinse tanks, hot water reservoir and cold water
reservoirs. Clean them according to CLEANING INSTRUCTIONS if minerals or film are
present.
RELATIVE HUMIDITY CONTROL ( )
humidity is desired, the control should be turned counterclockwise toward " "; and if
higher humidity is desired, clockwise toward "
NOTE: When you unpack your humidifier, you may find it has droplets of water on
some surfaces. This is normal as every unit is tested prior to shipping. Carefully unpack
humidifier and remove all packing material.
OPERATING INSTRUCTIONS
1. Place the base of the unit on a firm, flat, level and water resistant surface.
2. Fill the water tanks according to the instructions below and place on humidifier base.
3. Plug the power cord firmly and completely into the wall outlet.
4. Push the power switch to the ON position (Lights may flicker momentarily). Then
turn the relative humidity knob clockwise until you hear a faint click. It will be
normal for the humidifier to take a few minutes to warm up and begin to mist.
5. When the water tanks are empty, (after approximately 24 hours running time), the
"REFILL WHEN LIT" lamp will go on, and the unit will stop heating. Refer to the
"FILLING THE WATER TANKS" section.
6. Whenever the water falls below the level of the float switch during operation, the
heating element will shut off and stop heating, and the REFILL indicator will light.
7. The unit will operate as long as there is water in either tank and unit will operate
with either one or both tanks.
FILLING THE WATER TANKS
1. Before filling the water tanks, push the POWER switch to the "OFF" position and
unplug unit. Refer to cleaning instructions.
2. Remove water tanks from base, turn each tank upside down and remove tank cap
by turning counterclockwise. Fill tank with clean cold tap water.
Replace the tank cap by turning clockwise. Tighten firmly.
3. Carefully pick up tank, since it will be heavy when full, and slippery if wet.
4. Place water tanks on base. Make sure tanks are properly placed, otherwise, the
humidifier will not work correctly.
EWM-220_OM.indd 5
)
- When illuminated, the water tanks need
- This controls the humidity level. If moderate
".
3/26/07 2:53:56 PM
Publicidad
