Publicidad
Idiomas disponibles
Idiomas disponibles
Always disconnect the LP cylinder from the regu-
lator assembly and remove the LP cylinder from
the heater before putting the heater into storage.
If, for any reason, the heater is to be stored in-
doors, the heater MUST be disconnected from the
LP cylinder, and the cylinder stored outdoors in a
well-ventilated area, out of the reach of children,
and in accordance with the Standard for Storage
and Handling of Liquefied Gasses, ANSI/NFPA 58
and Natural Gas and Propane Installation Code,
CSA B149.1- latest edition. The plastic valve plug
or valve cover supplied with the LP cylinder must
be reinstalled on the valve to protect the fitting
from damage.
NOTE: Repair of this heater should be done by a
qualified service person.
It is recommended that you save all of the pack-
aging materials that came with your heater, and
re-package the heater using these materials for
safe storage.
Debris, dust and dirt inside of the heater body
can affect the performance of your heater. This
debris can impair the heaters ability to draw air for
ventilation and combustion. Spiderwebs can also
appear during periods of inactivity.
DANGER
CAUTION
© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED
TO A POWER SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE.
STORAGE / MAINTENANCE
Never store an LP cylinder inside of a building or near any other gas or
oil burning appliances.
Always be sure that the heater has been allowed to cool for at least 30
minutes before attempting to store, service, or perform maintenance.
Be sure to inspect the heater before each use to
look for any such obstructions. Be sure to keep
the air passage-ways, burner and combustion
areas clean. Wipe with a damp cloth or use a
vacuum cleaner to clean these areas. It is sug-
gested that you perform a thorough cleaning at
least once every 30 days of operation. You may
need to clean the heater more often if conditions
are naturally dirty. Clean the heater, including spe-
cial surfaces, with recommended cleaning agents,
if necessary.
Clean the ceramic plaques using compressed air
below 30 PSI to prevent damage to plaques.
A yellow tip of the pilot flame indicates that the
burner area may be in need of cleaning.
11
Cabinet Heater User's Manual
Publicidad
