One for All URC6131NOM Guia Del Usuario página 10

One For All 6-Device PVR Universal Remote Control
For example, to find out which code is
operating your TV:
1. On the remote control, press TV once.
2. Press and hold SET
light) blinks twice, then release SET.
9 9 0
4. To view the code for the first digit,
press 1 once. Wait 3 seconds, count
3) and write down the number in the
leftmost box in the TV code boxes on
page 6.
NOTE: If a code digit is 0, the LED will not
5. Repeat step 4 three more times for
remaining digits. Use 2 for the second
digit, 3 for the third digit, and 4 for
the fourth digit. Write down the code
digits in the remaining TV code
boxes on page 6.
6. To check for codes of other devices,
repeat steps 1 through 5, but
substitute the appropriate device key
for each device you are checking.
Write down the device's code digits in
the appropriate code boxes on page 6.
PROGRAMMING MASTER POWER
In its default state, the POWER key
on the URC-6131 remote control
will individually power your home
entertainment devices on or off.
However, you can also program a Master
Power function onto the POWER key that
will sequentially turn on or off all the
devices with a single key press.
PROGRAMMING THE POWER KEY FOR
MASTER POWER
1. Press and hold SET
light) blinks twice, then release SET.
9 9 5
Then press POWER once.
8
3. For the first device you want in the
power on sequence, press its device
key (e.g., CBL/SAT) once.
4. Repeat step 3 up to five more times to
add desired devices to the power-on
sequence.
5. To save the settings and exit the
program, press and hold SET until the
OPERATING MASTER POWER
1. After programming, point the
remote control at the devices and
press POWER for at least 2 seconds
to sequentially turn on or off your
devices.
NOTE: When you press POWER for less than
2 seconds, the remote will only send a
device. This allows you to still individually
power devices on or off.
off according to your programmed
sequence.
NOTE:
always turn on first, followed by the
remaining programmed sequence. After
the master power sequence is complete, the
device.
NOTE: If one or more devices does not have
may be slightly delayed when the remote
control signals the device(s). This action is
normal.
CLEARING MASTER POWER
1. Press and hold SET
light) blinks twice, then release SET.
9 9 5
Then press POWER once.
3. Press and hold SET
blinks twice, then release SET
Power is now cleared.
SET.