Escalade Sports ELITE Instrucciones De Montaje página 12

IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREWS IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
NOTE: Note: Hinges must always be positioned as shown, with the "elbow" of the hinge pointing
toward the bottom of the table. In the correct position hinge will look like a "V",
rotate hinges into position if necessary.
11. Align the holes in the Hinge Bracket Assembly (#18) with indentations in table
top. Be sure that the straight part of the hinge is facing toward the middle of
the table and placed exactly as shown in Figure 9, Detail E1 & E2.
Hole on the straight
leg of hinge should
be facing up
5
The "elbow"
of the hinge should
be pointing towards the
bottom of the table
Detail E1
NOTICE
18
(Position A)
NOTE: If using electric
screwdriver set at low
torque. Do not over
tighten screws.
Figure
9
12
HARDWARE NEEDED
5
#8 X 9/16 Screw
(Qty. 8)
Hole on the straight
leg of hinge should
be facing up
The "elbow"
of the hinge should
be pointing towards
the bottom of the table
Detail E2
18
(Position C)