Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWARE NEEDED
5
#8 X 9/16 Screw
(Qty. 29)
14. Lay out Rails (#2, #3, #23 & #44) around
edges of table top. See Figure 11.
15. Place Ball Holder end Plugs (#7) in both ends of Ball
Holder End Rail (#4). See Figure 11 & Detail G.
16. Line up holes in rails with Indentations in table top and
secure using Screws (#5). See Figure 11 & Detail H.
Note: All Indentations
guides in table top are
small so look closely.
Stiga logo
on this side
Figure
11
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREWS IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
7
23
23
3
NOTICE
Detail G
4
44
R a il s
B e n d s o n
o th e r
fa c e e a c h
14
5
Detail H
44
Stiga logo
on this side
5
2
Publicidad
