Publicidad
Idiomas disponibles
Idiomas disponibles
•
Carefully remove products and accessories from the box. Check that all items listed above are included.
•
Inspect the product to make sure it has not been damaged or broken while being transported.
•
Do not discard packaging materials until you have had the opportunity to carefully inspect the product and have
used it satisfactorily.
ATTENTION: If there are damaged or missing parts, contact the Official Technical Service. Do not
use this product without replacing the damaged or missing part. Use of this product with damaged
or missing parts can cause serious injury to the operator.
ASSEMBLY
ASSEMBLY OF THE CHAIN AND THE SWORD
1.
Be sure to remove the battery from the unit. Wear protective gloves.
2.
Unscrew the chain tensioner knob and remove the sprocket cover.
3.
The saw chain should face in the direction of the chain rotation, if it faces backwards, rotate the cycle.
4.
Place the chain drive links in the groove of the sword.
5.
Place the chain so that there is a link on the back of the sword.
6.
Hold the chain in position on the bar and place the link around the drive sprocket. Lower the bar so that the
bolt passes through the hole in the chain tension assembly. You may need to rotate this assembly to align
the bolt and hole. You can rotate this assembly again to apply some tension to the chain, which will help
keep it in place.
7.
Replace the sprocket cover and turn the chain tensioner knob until it is tight, turn the chain tension
adjustment ring until the saw chain is properly tensioned. The sword should then be pushed upwards, check
the chain tension again, do not over-tension the chain.
8.
After the chain is properly tightened, tighten the knob again.
1
1
2
1
1
1
59
EN
Publicidad
