Publicidad
Idiomas disponibles
Idiomas disponibles
Service
Battery Removal
WARNING!
accessories contain lead and lead compounds. Wash
hands after handling.
The battery is located on the right/rear of the tractor beneath the
seat box frame. To remove the battery:
1.
Remove the two hex tapping screws from the battery
hold-down bracket and remove the bracket. Use care to
avoid losing the trim strip from the bottom of the bracket.
See Fig. 7-1.
Battery Hold Down Bracket
2.
Remove the hex cap screw and sems nut securing the black
negative battery lead to the negative battery post (marked
NEG). Move the cable away from the negative battery post.
3.
Remove the hex cap screw and sems nut securing the red
positive battery lead to the positive battery post (marked
POS).
4.
Carefully lift the battery out of the tractor.
5.
Install the battery by repeating the above steps in the
reverse order.
WARNING!
battery before connecting the negative lead. This
will prevent sparking or possible injury from an
electrical short caused by contacting the tractor
body with tools being used to connect the cables.
28
Battery posts, terminals and related
Hex Tap Screw
Trim Strip
Figure 7-1
Always connect the positive lead to the
Charging the Battery
Test and, if necessary, recharge the battery after the tractor has
been stored for a period of time.
•
A voltmeter or load tester should read 12.6 volts (DC) or
higher across the battery terminals. See Fig. 7-2.
Voltmeter
State of
Reading
Charge
12.7
100%
12.4
12.2
12.0
Figure 7-2
•
Charge the battery with a 12-volt battery charger at a
MAXIMUM rate of 10 amps.
Servicing Electrical System
A fuse is installed to protect the tractor's electrical system from
damage caused by excessive amperage. Always use the same
capacity fuse for replacement. If the electrical system does not
function, check for a blown fuse.
If you have a recurring problem with blown fuses, have the
tractor's electrical system checked by your Cub Cadet Service
Dealer.
Relays and Switches
There are several safety switches in the electrical system. If a
function of the safety interlock system described earlier is not
functioning properly, have the electrical system checked by your
Cub Cadet Service Dealer.
Deck Removal
Remove the mower deck from the tractor as follows:
1.
Move the tractor to a level surface, disengage the PTO, stop
the engine, and set the parking brake.
2.
Move the deck gauge wheels or rollers to their highest
setting (lowest deck setting).
3.
Remove the 'V' belt from the PTO pulley, located on the bottom
of the engine, using one of the following two methods.
WARNING!
The muffler at the rear of the tractor
may be extremely hot, and could cause serious
burns. Use extreme caution when near the muffler.
Allow the muffler to fully cool before removing the
belt from the PTO pulley.
Releasing Belt Tension with the Idler Pulley
1.
Using the deck lift handle, raise the deck to the position
that provides the most horizontal run of the belt between
the deck idler pulleys and the PTO pulley on the bottom of
the engine.
7
Charging
Time
Full Charge
75%
90 Min.
50%
180 Min.
25%
280 Min.
Publicidad
